Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

Restoring a 1977 280z! (My first z car)


Jacob Grimm

Recommended Posts

Me? It means you've got what looks like a great start for project. It means we've all been there. Stuff will be out of place. Stuff will be missing. Stuff will be wired wrong. Stuff will be put on backwards. Stuff will be leaking because it's too loose or too tight or because it's standard thread when it should have been metric.

 

It's standard operating procedure.   :)

 

  • Like 1
Link to comment
Share on other sites

Or me? I don't have a photo with me at the moment, but can post a photo of both versions end next week. I have spares of both versions of AFM (Air Flow Meter).

Early version: (Your car) has the full seven pins in the wiring harness connector. The last two pins are for the fuel pump relay. Basicly the pump will only run if the engine is running and sucking in air. Its a safety device to stop the pump if the engine stops in an accident etc.

Later version: Uses the oil pressure sender to do this. The later sender has two prongs where yours will have one. It works the oil pressure gauge and allows the pump to run. Its located down next to the oil filter.

You can use the later version, if you can't find a good servicable early unit, but then you will need the later version of the oil pressure sender and run wiring over to it.

Bridging the wires in the harness is not a good idea, because you would then disable a safety feature.

Link to comment
Share on other sites

Moi?  There was discussion that the car might be an almost original condition, low-miles, "survivor" type car.  But it looks more like a normal, been worked on, not quite right car now.  More fun in the long run because you don't have to worry about ruining something special.

 

Considering the loose wiring and the missing parts and the fact that it doesn't have what it needs to run anyway, it's in perfect position to get a multimeter, and the Engine Electrical, and Engine Fuel chapters, and the 1980 Electronic Fuel Injection Guide, and just spend some time taking measurements, and making everything right.  Then when you're ready to put a battery in it and see what works, you won't get any surprises.

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.