Hi, could someone tell me the bolt size for the front fender to the body.  It's a 10mm head and I think 6mm bolt.  Fine threads??  I'm having a little trouble sourcing them.  Any help is appreciated.  My original hardware is pretty rusty and I'd rather replace it than get into tumbling and zinc plating them if I can help it.  

Here you go....

 

http://www.thezstore.com/page/TZS/PROD/14-1223

 

Here you go....

 

http://www.thezstore.com/page/TZS/PROD/14-1223

 

Thanks.  I feel stupid for not looking there.  I was so busy trying to find them at Belmetric and other places that I didn't try the obvious choice.  

 

Nice 370z BTW.  I have a 350z NISMO and a 1976 280z (was running too... getting closer to running again).

Thanks.  I feel stupid for not looking there.  I was so busy trying to find them at Belmetric and other places that I didn't try the obvious choice.  

 

Nice 370z BTW.  I have a 350z NISMO and a 1976 280z (was running too... getting closer to running again).

 

Your 280 looks a lot further along than mine !

 

My 370 was purchased while I was deployed in Afghanistan... I sooooo wanted a 280 while I was in high school but could never swing it back then. The 370 was the closest thing to it and the 350 just didn't seem right (as a relative of the S30 series; just wasn't the same design).

 

I am loving having the 280 now, and at a time in my life when I can afford to restore it properly! Time and money wise !

 

* I can't tell from the photo, but make sure the heads of the bolts are thinner than normal to clear the hood... special head design for the fenders.

M6 X 1.0 thread size