1971 HLS30-14938 "Lily" build

[SteveJ]

16 minutes ago, Patcon said:

Yeah, that would be a nice picture to end with. Definitely getting gray. Might get my kids in that one too. They've changed a lot too

I was shocked to see the more recent photos of Cody. I hadn't seen him since 2018.

[Patcon]

8 minutes ago, SteveJ said:

I was shocked to see the more recent photos of Cody. I hadn't seen him since 2018.

He's changed a lot in 5 years! He's 6'7"+. He's a Caterpillar heavy equipment field mechanic

[SteveJ]

32 minutes ago, Patcon said:

He's changed a lot in 5 years! He's 6'7"+. He's a Caterpillar heavy equipment field mechanic

Working for Blanchard?

[CanTechZ]

11 hours ago, Patcon said:

So I started pulling the rear body harness in. There are two branches that go up. One for the dome light. One for the defroster.  The dome light is self explanatory, but how does the defroster route? All in the structure or only internal until its under the plastic?

Here are some pics that might help that I took as I was disassembling my 7/70. Basically as you described. HTH Mike

[CanTechZ]

On 2/25/2023 at 2:53 PM, Patcon said:

Also I have this selection of gas pedals:

Which was is correct for my 71?

2 have plastic pivots and one has a metal pivot. The one with the metal pivot is also shaped a little differently

 

 

My 7/70 has the plastic pivot bracket.

Edited April 9, 2023 by CanTechZ

[Patcon]

22 minutes ago, SteveJ said:

Working for Blanchard?

Yes

[Patcon]

@CanTechZ

Thanks MIke!

Those are just what I needed!

[Patcon]

Where did they use a pointed bolt like this on the car?

I believe it is 8mm x 1.25

 

[CanTechZ]

46 minutes ago, Patcon said:

Where did they use a pointed bolt like this on the car?

I believe it is 8mm x 1.25

 

Lower fender to rocker bolt.

[Patcon]

Super! Thanks

C

[CanTechZ]

22 minutes ago, Patcon said:

Super! Thanks

C

You're very welcome. 

[Captain Obvious]

11 hours ago, Patcon said:

He's changed a lot in 5 years! 

Not sure if he got much taller, but he's certainly wider!    :

And shoutout to @Mark Maras