What is part #30??

https://www.carpartsmanual.com/datsun/Z-1969-1978/body-240z/front-fender-hood

1 hour ago, Patcon said:

What is part #30??

https://www.carpartsmanual.com/datsun/Z-1969-1978/body-240z/front-fender-hood

It is a gasket between the sugar scoop and the fender.

8 minutes ago, jfa.series1 said:

It is a gasket between the sugar scoop and the fender.

Any idea on a source for those? Those aren't the ones for the headlight to bucket are they?

19 minutes ago, Patcon said:

Any idea on a source for those? Those aren't the ones for the headlight to bucket are they?

NLA at Nissan. Not for the headlight, a thin gasket where the sugar scoop fits against the fender. They had completely disappeared from my car by the time I took it apart. I made no attempt to replicate for my build.

2 minutes ago, jfa.series1 said:

NLA at Nissan. Not for the headlight, a thin gasket where the sugar scoop fits against the fender. They had completely disappeared from my car by the time I took it apart. I made no attempt to replicate for my build.

Are there any pictures around for what they looked like? I might try to replicate them.

I dropped off the remainder of my panels at the paint shop today. I suspect they will be ready next week.

Headlight Gasket Rubber Seal 240Z 260Z 280Z | Z Car Depot Inc

3 hours ago, dutchzcarguy said:

Headlight Gasket Rubber Seal 240Z 260Z 280Z | Z Car Depot Inc

I dont believe that is the same item. I believe there is supposed to be another seal a the bucket to fender joint

 

Edit: checking car parts manual shows totally different part numbers

#30

https://www.carpartsmanual.com/datsun/Z-1969-1978/body-240z/front-fender-hood

#12

https://www.carpartsmanual.com/datsun/Z-1969-1978/electrical/head-lamp

Edited September 16, 20231 yr by Patcon

Worked on the fuel tank and vent lines today. Made gaskets for the wiper pivots

Expander in the filler neck. A tip for the future, put the tank straps into the car body before lifting the tank into place. They are difficult to get in after the fact. I made some progress on the tank but I need a spring to keep the top front port on the tank from collapsing and I didn't have enough double wire hose clamps

Does anyone know of a source the marker light screws? I would like to purchase them in bulk...

BelMetric doesn't seem to carry that kind of screw

@jfa.series1might know 

12 minutes ago, Yarb said:

@jfa.series1might know 

All of mine have come from rotted out / damaged lights that I parted out. I have a small supply of the shorter ones.

I believe the 300zx might have used a similar stainless screw in black. If I could find those, I would bead blast them or buff them...

Ordered 10pcs of 01451-00041 from Courtesy parts. We'll see if they're black or clear finished. They're not real cheap