Where is a good place I can get a good and cheap (i know its a bit contradictory). I have a 76 280z with a stock engine (Fuel Injected as well), also where is a cheap place I can get a 3" 90 degree mandrel bent elbow to convert my old air intake to a cold air with K&N?

i once was going to do a stainless steel mandrel bent exhaust for my 240Z i had. i priced all parts from Jc Whitney. the cost was a measily if i recall right somewhere between 140 and 170.

not to bad huh.

if you go to www.jcwhitney.com you can find mandrel bends that you could use for your intake.

you might also want to make your own exhaust as well just have it put together at a muffler shop.

good luck with whatever you decide

if i wanted to go from header (is that where the exhaust system starts? im new with cars) to the tailpipe which tubes would i need? I know Im basically asking for you to do the work i need to do but i dont want to get a wrong tube and waste money.