Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

differential identifying by the housing?


jlenownnab

Recommended Posts


Easier to just look at the rear cover, or the area around where the axles insert.  The R200 has a rectangular chunk of aluminum, about 1/2" by 1", underneath the drain plug and the cover is almost round.  The R180 is smaller and has a rectangular rear cover.  It also has a ring of bolts around the axles holes, where the R200 does not.  Look at some images on the internet and you should be able to tell with a glance.

If your 75 is a manual transmission coupe it's almost certainly an R200.

Or you could post a picture and we'll just tell you what it is.

Link to comment
Share on other sites

If you're not sure which ratio R200 you have lying around the garage, check it this way: Remove the rear plate (drain the oil of course). Then rotate the large ring gear until you see these numbers stamped into the edge facing you. 

  • If it's a 3.54 it will read "39:11"
  • If it's a 3.70 it will read "37:10"
  • If it's a 3.90 it will read "39:10"
  • If it's a 4.11 it will read "37:9"
    Link to comment
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...

    Important Information

    By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.