Jump to content

IGNORED

PerTronix Ignition Kit Tachometer Bounce


cremmenga

Recommended Posts

I've searched on here, on hybridz and all over about the dreaded pertronix ignition tach bounce fix.  I find lots of places talking about it but nothing on fixing it besides getting a different tach.   I have the  3.0 ohm coil that came with the kit and I bypassed the resistor just like the installation instructions suggested.   My 1973 240z now starts a thousand times better and faster and the throttle response is great and seemed to pick up some power.  The problem for me is between 3000-5000 rpm the tach will drop to zero then bounce like crazy.  I don't experience and problems with misfiring or the actual rev of the motor, just the tac.  Has anyone found a solution to this common problem yet? 

Link to comment
Share on other sites

I had the bounce, but most of the time the needle would get to 4000 then freeze and drop to 0 and when the revs came down under 4000 the needle would jump back up.  I replaced the tach but it didn't help.  I hunted through the archives too to find a fix but never found one that worked until I pulled the old distributor and replaced it with the Ignition123 dizzy, that fixed it for good.

Link to comment
Share on other sites

  • 4 weeks later...

I just finished the PerTronix upgrade using the new Ignitor II electronic ignition with solid state dwell compensation plus Flame Thrower Coil on my '72 240Z, 11/71 production with original tach. I opted for the 1.5 ohm coil so I could retain the Ballast resister in order to mimic the original wiring as much as possible just to try and avoid tach issues. Plus (most importantly) I used the John Hull wiring diagram, see link. Carefully following the wiring diagram, and spending about 3 hours total, I buttoned everything up, turned the key and my car fired right up with the tach operating normally. My idle has increased to about 1100 over the original 900 which I will adjust but the car seems to run very smooth with better acceleration and no tach issues. Hope this helps...

www.zhome.com/ZCMnL/tech/ZXPertronix.htm



Sent from my SAMSUNG-SM-G900A using Classic Zcar Club mobile

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.