Orlando FL shop

[Dave WM]

Prob been covered before, I searched found some old data.

I keep putting off doing my trans swap (rear main, clutch, trans swap 5 for a 4 speed) due to fear of the unknown.

anyway looking for good shop that knows how to work on old Z's (1975 280z). Found a website for Z tech in longwood FL.

any others, looking for feed back on Z tech or other shops for this kind of work.

[JSM]

Dave, post a link.  The Z tech I remembered is long gone and was in College Park. 

 

[Dave WM]

http://www.ztechorlandofl.com/

spoke to Avi (sp?) still there.

He said bring the car by during the week, with the transmission to discuss.

Edited March 3, 2017 by Dave WM

[JSM]

Interesting. When you go ask them if they used to be in College Park.


Sent from my iPhone using Classic Zcar Club mobile

[Dave WM]

been in bus since 1980 looks like, he is the owner. I will drive by and talk see how it goes. I don't mind paying as long as I know its done right.

[JSM]

Hey Dave if you go will you ask if they have a paint and body guy they would recommend.


Sent from my iPhone using Classic Zcar Club mobile

[Dave WM]

will do, plan to go some time next week. I attempted to get started on the trans swap, car on jacks, penetrating oil on exhaust studs (remove exhaust pipe for access) impact gun, promptly snap off nut.... enough of that I will take it in and see what its going to cost. I prob should have heated with oxy/ace torch, all I had was a propane, not hot enough i guess. Anyway enough of that.

I will check them out and let you know. I would have thought there would be more folks here that have used them.

[Dave WM]

Plan B go to a local muffler shop to see what they would charge to loosen up those done pipe nuts, and get the snapped on out.