Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

TC bushings 280z 1975


Dave WM

Recommended Posts


ok so old ones that I have which are not too beat up, you can clearly make out a radius on the inside bead. The radius is not centered in the bead but rather is centered on the outside edge of the bead (the relief cut on the bushing). The location of the radius would seem to provide for correct geometry for bending forces when installed with the radius centered high.

note the pic posted by CO is of the replacements where the radius looks to be centered. I suspect all this is  moot since the differences in actual performance are I am quite sure are negligible.

Link to comment
Share on other sites

  On 3/13/2017 at 7:49 PM, Zed Head said:

Those are aftermarket and don't seem to have a front or back.  Does make things easier though.  Or are you just messing with us?

Expand  

They have a flat side and a rounded side, the rounded side goes out against the cup washer, the flat side stays in the middle on both sides up against the frame.  Those are hyperflex polyurethane I believe? 

03.jpg

tceurothane.jpg

"Not all bushings are made alike. Some can break T/C Rods.
G-Machine on left and Hyperflex on right."

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.