Jump to content

IGNORED

Stupid gas gauge question


hawk11

Recommended Posts

This is probably a stupid easy question for you guys.  But I'm new to owning a 280z.  I have a 78 by the way.  My question is I'm unfamiliar with how the gas gauge is supposed to operate.  I know it's a float unit and I've never owned a car with one before.  Mine for example right now is on just above slightly a half a tank.  But while I'm driving or even sitting still it moves a little, not much, just sometimes it's a half, then maybe a few seconds later it's just above a half slightly where it finally rests.  When I drive it seems to go up when I stop etc.  Is this normal, and due to the float, or should the gauge be still always and not have a lot of movement.??  

I know it's a dumb question but if your share some insight into what's "normal" operation for a 280z fuel gauge I would really appreciate it.

 

--  

Link to comment
Share on other sites


My '77 stays pretty stable while driving.  Here's a couple of things to look at that'll help understand the way they work.

DSC08610.JPG

Open the hatch and you'll find the round cover that's over the sending unit.  If you touch the two wires together the gauge should go to EMPTY.  EDIT!!! maybe FULL, can't remember:rolleyes:

DSC00534.jpg

 

Edited by siteunseen
Link to comment
Share on other sites

10 hours ago, rcb280z said:

Site, is that a new sending unit?

Yes Sir, shiny and clean but for a 240.  I don't know if the 280's are still available but the 240's are.  Seems like I paid $47, plus the 0-ring it was all $50.

I guess I don't drive as hard as you guys, I can't remember my needle moving while I'm driving. 

I do keep a full tank though.  Lesson learned from my earlier days. :D

Link to comment
Share on other sites

The 280 senders (side mount) have an "empty" sensor and an extra wire for that. Little red light on the fuel gauge will light up. Other than that they are identical (other than the connector) to the 240 senders if you need one and can't find a 280 sender.

Edited by zKars
Link to comment
Share on other sites

The 280 senders (side mount) have an "empty" sensor and an extra wire for that. Little red light on the fuel gauge will light up. Other than that they are identical (other than the connector) to the 240 senders if you need one and can't find a 280 sender.

This is true! You could build a new one out of a 240 sender! 280 one below...
PB250079.JPG
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.