Bought # 4858

[tamo3]

Hmm? why P79 head????

[siteunseen]

Is that some type of ceramic heater to get hot enough to straighten cylinder heads?  

You got one helluva hack saw!

[madkaw]

Cut off wheel(ssss) 

straightening a n47 head in a kiln

[Zed Head]

Looks like a nice work holder for the port grinding you're doing also.

Have you tried the heater yet?  Probably makes a nice pizza too.

[madkaw]

Yes- makes for a nice heavy stand . Yes - I’ve had one semi successful run and it works pretty well. Need to dial in my technique.

[Patcon]

3 hours ago, madkaw said:

Yes- makes for a nice heavy stand . Yes - I’ve had one semi successful run and it works pretty well. Need to dial in my technique.

Who's into ceramics?

[siteunseen]

Nice for setting the wipe pattern too, pretty much any head work.  I had to use a overhead chain hoist to get a bare block on my work table.  The one you have looks liftable by hand.  I wonder if a plasma cutter would work?  I got a friend that knows a guy...

[madkaw]

2 hours ago, Patcon said:

Who's into ceramics?

Guy powder coats with it . 

[madkaw]

5 minutes ago, siteunseen said:

Nice for setting the wipe pattern too, pretty much any head work.  I had to use a overhead chain hoist to get a bare block on my work table.  The one you have looks liftable by hand.  I wonder if a plasma cutter would work?  I got a friend that knows a guy...

Anything that cuts- torch , plasma cutter , partner saw would be the fastest 

[Patcon]

1 hour ago, madkaw said:

Guy powder coats with it . 

Oh, cool. Looks like it might have been a ceramics kiln at one point

[madkaw]

4 hours ago, Patcon said:

Oh, cool. Looks like it might have been a ceramics kiln at one point

It was meant to be 

[madkaw]

Rotisserie started!