4 hours ago, EuroDat said:

What type of pump are you using?

He hasn't answered this yet.

If it were wired backwards he may be able to hear it gurgling in to the tank right?

Just an FYI 10 years is a long time for those injectors.  I would also verify you can hear each one clicking. I had a 300ZX I just went through that was sitting for 2 years. None of the I jectors would fire. I had to clean them one by one and lube and apply voltage on and off until they freed. 

If i recall right, there was a warning in the user manual of the 280zx that if you run it dry the tank has to be filled for more than 3/4 !  otherwise the pump will not get the fuel to the injectors.. my two cents..

The standard pump has a check valve. What type of pump are you using? Original or aftermarket?

Sorry got busy with work haven't checked up on this thread till now I'm using an inline pump similar to the one on the car the first photo is what came off the car the second what's on it15251306034401525130662982

Sent from my [device_name] using http://Classic Zcar Club mobile

There's no second.

There's no second.

Sorry here it is

Sent from my [device_name] using http://Classic Zcar Club mobile

Sorry here it is

Sent from my [device_name] using http://Classic Zcar Club mobile

It's not showing the first picture I sent it only showing numbers so just in case here is the original pump

Sent from my [device_name] using http://Classic Zcar Club mobile

The new eyelets show that it's possible that you have it wired backward.  If you look very closely I think that you'll find a + and a - molded in to the ceramic (or plastic.  Whatever the white material is) where the wire terminal studs are.  The green wire goes to +.

The new eyelets show that it's possible that you have it wired backward.  If you look very closely I think that you'll find a + and a - molded in to the ceramic (or plastic.  Whatever the white material is) where the wire terminal studs are.  The green wire goes to +.

I'll try flipping them

Sent from my [device_name] using http://Classic Zcar Club mobile

The new eyelets show that it's possible that you have it wired backward.  If you look very closely I think that you'll find a + and a - molded in to the ceramic (or plastic.  Whatever the white material is) where the wire terminal studs are.  The green wire goes to +.

I meant to take your advice sooner and double check but got busy with life

Sent from my [device_name] using http://Classic Zcar Club mobile

Ok so zed head I swapped the wires around and now my passenger side blinker started going nuts and the pump bogged down??? What's up with that

Sent from my [device_name] using http://Classic Zcar Club mobile

It's just two wires, and a DC motor.  Can't really screw that up beyond accidentally shorting the power wire and blowing a fuse, or connecting the wires backward.  Those are, really, about the only two things that can go wrong.

Sorry.  Keep it simple.  You might have accidentally bumped some other wires or discovered an already existing problem.