Fender Emblem Installation

[siteunseen]

3 hours ago, Captain Obvious said:

LOL. Cliff in a library? This is what I picture:

 

Surely you're kidding?

[psdenno]

43 minutes ago, siteunseen said:

Surely you're kidding?

Don't call me Shirley!

Sorry, I tried to resist.  But it's hot here and I'm not making good decisions.

Dennis

[siteunseen]

14 minutes ago, psdenno said:

it's hot here and I'm not making good decisions.

Dennis

Same here.  I haven't been out in 3 days.  Going a little stir crazy, alcohol helps. 

 

[wheee!]

Send heat this way... we have had three days no rain since May....

[psdenno]

2 hours ago, wheee! said:

Send heat this way... we have had three days no rain since May....

Currently, it's a balmy 117º F ( 47º C ) and climbing.  If I can find a big enough box, it's your's.  ?

Dennis

[wheee!]

I'm in.... after 65 degrees Celsius in Afghanistan, I can handle anything.... except constant moisture. ?

[psdenno]

5 hours ago, wheee! said:

I'm in.... after 65 degrees Celsius in Afghanistan, I can handle anything.... except constant moisture. ?

Topped out at 119º today.  More of the same tomorrow.  I can't wait to see my electric bill this month.

Dennis

[87mj]

On ‎8‎/‎13‎/‎2019 at 8:29 PM, Jughead said:

ZedHeads, 

Whats the best way to install the "DATSUN" fender emblems.  I juts got my new one and want to make I do it right the first time.  Is it as simple as pushoing the posts thu the holes until the lock washers engage?  Glue recommended?  Anything else?  THANKS!!!!

I installed the barrel clips on the posts of my metal B pillar emblems and push them on without adhesive.  They went in great.  Then I put the barrel clips on the posts for the rear hatch and hood emblems.  They went on just as easily although I had to press them in a bit harder.  They were plastic.  No adhesives.  I haven't installed the front fender emblems yet but I don't expect any problems regardless of outdoor weather conditions.

[jfa.series1]

6 hours ago, 87mj said:

I installed the barrel clips on the posts of my metal B pillar emblems and push them on without adhesive.  They went in great.  Then I put the barrel clips on the posts for the rear hatch and hood emblems.  They went on just as easily although I had to press them in a bit harder.  They were plastic.  No adhesives.  I haven't installed the front fender emblems yet but I don't expect any problems regardless of outdoor weather conditions.

What he said ^^^.  It doesn't hurt to put a wee bit of lube (just a film coat) on the barrel clip prior to pushing it thru the sheet metal.