240Z Half Shaft Question

[HappyZ]

I sent this question to WoodWorkerB but thought I’d post here as well.

Half Shaft Rebuild

I rebuilt one half shaft following @wooodWorkerB’s guidance, but I’m having a problem.

http://woodworkerb.com/home/datsun-240z-rebuild/half-shaft-rebuild/

I can assemble it but only with the bearing/spacer mix pushed all the way to the end of the sleeve yolk to the point where I can barely get the plug and snap ring in place.  There is no movement of the sleeve and shaft once assembled.  I had to really force the shaft into the yolk.

Does anyone recall if yours could slide in and out (even just a bit) when assembled?

any information is appreciated.

[HappyZ]

Does anyone have any experience with the rear axle?

[wheee!]

They should move fairly easily. How much grease did you pack in there? The FSM is very specific about how much to use and where. My thread has the complete half shaft disassembly and rebuild guide.

https://www.classiczcars.com/forums/topic/61539-s30-half-shaft-disassembly-and-rebuild/

Edited August 21, 2019 by wheee!