[2020] What Did You Do To/with Your Z Today?

[zed2]

New Year’s Day we will cut the slits in the cargo deck carpet to accommodate the luggage straps. What will you be doing?

Keith

[Patcon]

Either welding in panels or starting on filler & primer

265 days and counting!

[Diseazd]

I put up pictures in my garage of my two favorite Z Heroes in the world. Z Doctor of Roanoke (RIP) and Eiji Hosomi of Datsun Spirit. Merry Christmas all!

Edited December 24, 2019 by Diseazd

[Jeff G 78]

I am gathering components to upgrade my brake system.  I have the Z31 vented front rotors, Toyota 4X4 S12-W calipers, T3 spacers, Mustang GT rear vented rotors, Mustang GT rear calipers and Silvermine Stage 4 caliper brackets.  I still need a Wilwood 1" master cylinder, front race pads, and the fasteners for the rear brackets.  With any luck, I will start in a few weeks.  I will also make a jig to re-drill the rear rotors for the 4x114.3 bolt circle.  With a simple jig, I can easily replace the rotors with only a cordless drill and a few bits.

[240260280]

Drilled out spot welds in spare part #1 below. Now to clean it up and prepare for insertion in blue.

Body beating here I come!

 

Rust Termites got Blue's under cowl.

Edited January 11, 2020 by 240260280

[siteunseen]

You've been reading Playboy's Forums again.

 

[grannyknot]

Whoa, damn that salty air.

[siteunseen]

I have to ask because I have no clue but does y'all's snow have salt from the Atlantic?

[240260280]

Yes it is strange. The cowl on top is fine.... must have been a bad batch of steel in that part.

The air that blows off the ocean has latent salt.

Edited January 12, 2020 by 240260280

[240260280]

It is an interesting part.  Its back edge is the front face of the pinch weld at the bottom of the wind shield.  The back corners fold in where ~ 4 pieces of metal come together at the bottom of the A pillar. There is also weld bead, sealant and solder at those junctions. 

The front corners also have bead welds where the inspect hatch hinge mounts are attached. 

To clean up the part I hack out of the donor car involved some grinding and a lot of spot weld drilling.

Removing the panel from Blue will be fun.  I will get to it when I have the car gutted and stripped down.

Edited January 12, 2020 by 240260280

[the_tool_man]

I've had the fuel tank out for de-rusting and cleaning for some time now.  I finally got my son-in-law to come over and help me reinstall if.  I could get it mounted by myself.  Or, I could get the fill hose on the tank nipple by myself.  But I couldn't do both simultaneously without help.  Sorry, no pics.  Still need to finish chassis-side fuel hoses (with see-through filter), hook up the new fuel pump and replace the ignition switch.  Then it's ready to fire up again, and will hopefully run right.

[gwri8]

Battery Bling!  Finally got around to installing new battery terminals that have sat around about 4 months.  I like the way they look and will be great for the eye candy part of car shows but the functionality will require more effort. Instead of just a 1/2" (13mm) wrench,  I'll have to add a full set of Hex keys and a 9/16" to the tool carry kit.  The plastic covers look good too but there's Nooo Waay that I will ever let an Autozone guy replace the battery without me removing them first.