Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

D612-52 Distributor...have I messed up?


Clay C

Recommended Posts

I dismantled my distributor in hopes of cleaning it up and getting it ready to go back on my shiny rebuilt engine. I probably went further than I should have and removed the points plate. I found only 1 governor spring on the weights below the plate?? Is this correct. I didnt find any broken springs in the housing. The car seemed to be running fine before the tear down. Any diagrams I have found all show 2 springs. 

Also think I will just order another points plate since I may have screwed this one up taking it apart. Going back with the Petronix Ignition.

Link to comment
Share on other sites

Good luck finding a "points plate".  You probably mean breaker plate.  Either way, breaker plates are almost impossible to find.  If you didn't break the plastic bearing cage you should be able to reassemble it.  The wire spring clip is hard to get on, but it is possible.  The FSM describes taking it apart, so it is a normal thing.

I thought that they used two springs on all of the distributors.  But the FSM only mentions one.

image.png

 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.