280z - Rear Bumper Term and Door Bumper Advice

[Yarb]

Got it thanks, I’ll give it another shot tomorrow when I’m back at the shop.

[Captain Obvious]

9 hours ago, Yarb said:

 Looks like the center hole on the support brackets is Not a spot weld?

That center hole is not a spot weld. I suspect that was a locator feature. So you drilled out about the only part that is NOT holding it on.  Haha!!

Not a big deal. Stuff like that happens. 

[Yarb]

Newbie!!🍺🍺🍺

[Captain Obvious]

Haha! Well not for long! Keep screwing up like that and you'll soon be as experienced as the rest of us!  Haha!!   

[EuroDat]

6 hours ago, Captain Obvious said:

Haha! Well not for long! Keep screwing up like that and you'll soon be as experienced as the rest of us!  Haha!!   

Yes indeed, I'm very experienced.

[Yarb]

Well, Did much better in my opinion on the second go around. @EuroDat how you saved the brackets? Kudos to you!! Just opened up one other hole. Rookie mistake! But it looks like a Z Now!!

[Captain Obvious]

6 hours ago, EuroDat said:

Yes indeed, I'm very experienced.

Yeah, me too. After all the stuff I've screwed up, I might be an expert on some of it. 

Yarb, The progress looks good.

[Muzez]

On 1/1/2021 at 1:53 PM, Yarb said:

Jumping on this thread, Please forgive me. The first  photo of the sight shield is what I’m attempting to remove. I bought a spot weld cutter from ZCD. Drilled out the first spot weld and the bracket is still attached solid. Can anyone shed some light on this before I attempt the others? Here’s a pic of the first weld I removed and the next weld that I have not attempted.  Appreciate the guidance.   John 

No apologies needed, I need to do this in a week so a big thank you!