Jump to content
Email-only Log-Ins Coming in December ×

IGNORED

Car will not start


Wally

Recommended Posts

From the FSM on compression testing. Of course, you'll have to do it cold right now, but follow the rest.

image.png

Note that the compression ratio will probably be lower with the engine cold, but there should not be a lot of variation in readings.

  • Like 1
Link to comment
Share on other sites


2 minutes ago, Zed Head said:

Use something more flammable.  Starting fluid, carb cleaner, hydrocarbon brake cleaner.  Or gasoline.

And make sure it gets past the pistons in the carbs in to the runners.

will do. FYI though all fuel lines hooked up same as fuel pump and carbs....it should be getting gas...just check the little fuel filter up front and it has a little gas in it which had to have come from the fuel tank. Gas is fresh, only couple weeks old

Link to comment
Share on other sites

2 minutes ago, SteveJ said:

From the FSM on compression testing. Of course, you'll have to do it cold right now, but follow the rest.

image.png

Note that the compression ratio will probably be lower with the engine cold, but there should not be a lot of variation in readings.

thanks for that SteveJ. if i redo the compression test with all the plugs out at same time do you think i will get different results?

 

Link to comment
Share on other sites

34 minutes ago, Zed Head said:

 

You have reasonable cylinder pressures and the engine is spinning.  The engine should start.  So, spark is left as the unknown.  With the engine spinning that fast you should be able to get a nice stable ignition timing reading with a timing light.  If you can do that, it will tell a lot.

anyone can recommend a good timing light? dont have one and need to buy...all of em i see on amazon have bad top reviews.

Link to comment
Share on other sites

You might squirt some oil in the cylinders too.  Your low pressure numbers might be because the pistons aren't drawing in the air.

Could also be that your carbs aren't working right.  You don't know that the float bowls are full.

Starting fluid answers a lot of questions.  Big time saver.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 716 Guests (See full list)

×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.