Quarter glass trim panel screw

[Dave WM]

can anyone confirm the type of screw used in the middle of the piller trim? I think i see a screw and washer (machine screw) but mine is missing so now sure.

its the only place that has a small hole on the trim piece the rest uses the rivnuts (plastic).

[Dave WM]

10 minutes ago, Dave WM said:

double post

 

Edited February 12, 2022 by Dave WM

[AZ-240z]

Dave, I have a 1971 series 1 car, so not sure if what I have would be the same for your 280z.

the original trim screw for my car is a black oxide, self tapping, oval head Philips screw.  The

finish washer is a clear plastic rounded, or dished washer.  The screw measures approx 9mm

of thread length with a total length of approx 13mm.  See photos below.     
 

Hope this is what you are looking for.
 

[Dave WM]

thanks! I presume the . is the same. I looked at car parts manual online and I could not see it. will try a 240z there as well

[CanTechZ]

10 hours ago, AZ-240z said:

Dave, I have a 1971 series 1 car, so not sure if what I have would be the same for your 280z.

the original trim screw for my car is a black oxide, self tapping, oval head Philips screw.  The

finish washer is a clear plastic rounded, or dished washer.  The screw measures approx 9mm

of thread length with a total length of approx 13mm.  See photos below.     
 

Hope this is what you are looking for.
 

Thanks for posting this, my 1970 has the exact same screw and washer on the right side, but it has a self tapping screw on the left side that has an integral washer. Now I know which is correct.

Strange that this screw and washer is not documented in the parts book.