Rod Bearing Wear pattern (1975 280z)

[Racer X]

3 hours ago, corbenB said:

I do not have a welder, is there any way i could rent a tool for it? I'm trying to look around for one but i cant find one. any help would be appreciated. 

Looks like Cliff (@siteunseen) has your situation covered.

[siteunseen]

39 minutes ago, Reptoid Overlords said:

Maybe the nursing home is closer than I think haha.

Get you some bifocals.

 

[Racer X]

4 hours ago, Reptoid Overlords said:

Jeez, I can't imagine what I used that puller for then.  Maybe the nursing home is closer than I think haha.

Stubborn damper pulley? My foggy memory seems to recall two threaded holes on the center part. Can’t recall ever having difficulty sliding one off though.

Edited October 30, 2022 by Racer X

[Reptoid Overlords]

I'm thinking maybe oil pan gasket holes for the cap on the rear where the rear main seal sits? But that one has a single threaded hole as well if I remember correctly.  Luckily the OP has been set on the right course. Curious to find out what the debris might be..

Edited October 31, 2022 by Reptoid Overlords