'75 280Z - preparing for '06 350Z 6 speed drivetrain conversion

[HusseinHolland]

9 hours ago, grannyknot said:

No, I cut up my original gauge backs to fit them in, the car was so heavily modified there was no going back anyway.

OK - I hate to destroy perfectly good equipment - if they were rough/inop I wouldn't care. I'll have to see what happens DTR.

Edited January 8 by HusseinHolland

[grannyknot]

I was just on their site and they are now offering a stock looking Datsun 240Z face plate, wish they had that when I was buying from them.

https://speedhut.com/gauge-applications/legacy-classic-street-rod/classic-led-tachometers/classic-led-standard-tachometers/4-1-2-classic-tachometer-8k-rpm-dash-mount-jdm-datsun-z-series/?dd-link=0kx6p31reeb

[HusseinHolland]

Putting this here before I forget (again)

Both cars have the 3.54 FD ratio.

another tidbit from NewZed - 75 280 R200 has different flange than later years

[HusseinHolland]

Also forgot to add this here - last Nov. ZedHead pointed me to a TechnoToy kit for fitting the short nose R200 into the 280Z, so I could use the 350Z short nose I have (w/LSD), assuming I can figure the axle adaptation.

Another design linked by CalZ on HybridZ

 

 

[HusseinHolland]

NATS delete for the stock 350Z ECM