CanTechZ Posted January 18 Share #13 Posted January 18 As my glove box door is currently taken apart here is a reference picture showing the emblem with the pins and retaining clips intact, as it was originally assembled. 2 Link to comment Share on other sites More sharing options...
siteunseen Posted January 18 Share #14 Posted January 18 This worked for mine. 2 Link to comment Share on other sites More sharing options...
jalexquijano Posted January 19 Author Share #15 Posted January 19 12 hours ago, CanTechZ said: As my glove box door is currently taken apart here is a reference picture showing the emblem with the pins and retaining clips intact, as it was originally assembled. so if i already purchased a JDM reproduction emblem the only way to stick is using gorilla tape? Link to comment Share on other sites More sharing options...
Popular Post Patcon Posted January 19 Popular Post Share #16 Posted January 19 No, you could separate the halves of the glove box door and install it like the factory did 5 Link to comment Share on other sites More sharing options...
jalexquijano Posted January 29 Author Share #17 Posted January 29 (edited) Already installed the emblem. However, while adjusting the height so the lid could close properly 2 of the plastic tabs broke. I decided to order the skillard aluminium glove box and rear lid. Edited January 29 by jalexquijano 2 Link to comment Share on other sites More sharing options...
Jeff Berk Posted January 30 Share #18 Posted January 30 I like the door hinge. In 2020 I had to fit a new hinge in my glove box and used this because I didn't know Skillard made these: https://www.mcmaster.com/1588A742/ Link to comment Share on other sites More sharing options...
jalexquijano Posted February 11 Author Share #19 Posted February 11 Well i bought both skillard panel and glovebox. However since i have the gen II mini the metal glovebox wont fit. Now what?? Another roadblock. Link to comment Share on other sites More sharing options...
Yarb Posted February 12 Share #20 Posted February 12 Sometimes you have to adapt and fabricate when necessary. I understand this is not the solution you are looking for. Figure out where it’s binding and make an adjustment as needed. Once you move away from factory specs customization always seems to create problems such as what you’re running into now. 1 Link to comment Share on other sites More sharing options...
jalexquijano Posted February 12 Author Share #21 Posted February 12 I guess if i had bought the cardboard one it would have been easier to bend and get it in that hole. 1 Link to comment Share on other sites More sharing options...
Yarb Posted July 2 Share #22 Posted July 2 Yes It would Link to comment Share on other sites More sharing options...
jalexquijano Posted July 8 Author Share #23 Posted July 8 Well this was my approach to replacing the original cardboard and fabricating a glovebox. My only concern is how ro remove the clock gauge if the led burns and i need to replace it. Also if i need to remove or service the ac evaporator it will be difficult as the back panel is glued with silicone. Link to comment Share on other sites More sharing options...
Patcon Posted July 8 Share #24 Posted July 8 That's good. You came up with a solution. Good for you! 1 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now