Posted September 28, 200321 yr comment_51195 I finely started to reassemble the ol' blister . One thing I want to pass on , I was using the mariene clean on the inner fender , I have the fenders removed. there is a pannel that is just infront of the door that makes a chamber that the water draines from cowel . On the driver's side the pannel leaves a 1/4" gap that allowed water and debris to enter from the wheel area. There is also a large drain that dumps the water from the cowel into the cavity of the fender in front of the door , this is an area that debris collect and hold water , this area is seen as a rust prone area and is the front of t he rocker pannel. I am installing a 45deg pvc pipe fitting and a section of large vynal tubing from home base , to run from the cowel drain down to the bottom of the cavity and drain . This is to clear the water and debris from the cowl area. :classic: Link to comment https://www.classiczcars.com/forums/topic/8122-reassembly-finely-found-a-flaw/ Share on other sites More sharing options...
September 29, 200321 yr comment_51227 Been there, done that, had to use the t-shirt as a grease rag, oops.....It's a great tip and I wish I'd been the one to write it out but I've done so many mods and little tip fixes that it's hard to keep up or remember all that i've done. Link to comment https://www.classiczcars.com/forums/topic/8122-reassembly-finely-found-a-flaw/#findComment-51227 Share on other sites More sharing options...
Create an account or sign in to comment