Jump to content
We Need Your Help! ×

IGNORED

Hot fuse


240ZMan

Recommended Posts

I have a 73 340Z with a "new" fuse box. The previous owner had it replaced, but unfortunately one of the connections gets hot enough to burn a finger. I tried taking the box out and tapping the rivet/crimp with a 3/8" socket extension underneath and a drift on top, and it helped some, but it's still too hot for me to feel good about it. How have others dealt with this kind of problem?

The box is othewise in great shape (it should be - it looks brand new and from the receipts, it looks like he paid ~$200 - ouch!)

Thanks,

Daniel

Link to comment
Share on other sites

1. I believe that fuse is for the rear taillights.

2. I haven't added any extra electrical (yet)

3. It only get's hot when I have the lights on which I guess is because that's the only time the tailights (not brake lights) are in use.

What do you think?

Link to comment
Share on other sites

Originally posted by 240ZMan

What do you think?

Not being an Electrical wiz so I can only give basic suggestions.

Step one, clean ALL the connectors on that circuit (EVERY ONE OF THEM). Corrosion leads to poor connections which result in high current draws to complete the circuit.

Victor, or anyone else jump in, as we're reaching the limits of my electrical knowledge fast!

Link to comment
Share on other sites

Perhaps I can add a bit more: the fuse clip on the hot side is not physically has tight as it is on other fuses. I had thought I might be able to tighten up the rivet by tapping it, and it helped some, but after a few months it seems to be getting worse again. I'm thinking of soldering it, but I hate the thought of possibly melting the plastic around it so I was hoping someone would have some other ideas.

I saw another thread that suggested cleaning the multifunction switch to reduce the load, but I didn't understand how dirty connectors would increase the current draw. It usually works just the opposite.

Link to comment
Share on other sites

Originally posted by 240ZMan

I saw another thread that suggested cleaning the multifunction switch to reduce the load, but I didn't understand how dirty connectors would increase the current draw. It usually works just the opposite.

Sorry, I cannot explain it, it just does. Just like a dirty battery cable terminal can cause a no start condition, but you clean it and all is well.

Link to comment
Share on other sites

Before you do anything, take some emery cloth or fine steel wool and clean both fuse clips inside where the fuse contacts are, and replace the fuse with a brand new one. Sometimes that is the problem, little corrosion on an old fuse will cause it to get hot.

If that doesn't work, you'll need to check all the bulbs, contacts in the bulb holders and check the ground wires on the rear harness under the plastic tail light panel.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.