MSA Turbo Exhaust Install

[seerex]

ok I went with all of your suggestions and got the turbo exhaust from msa , hhm does anyone have a pic of it installed on their car so I can make sure to get on correctly , I know you are saying it only goes on one way but I am sure I can find another way <especially the wrong one> also does the tip have to be welded on at a muffler shop? and is recommend having a muffler shop tack it after I get it bolted in? any thoughts would be great thanks

[seerex]

actually its the aluminized and with the ssssuperrrr turbo muffler as if there was super diffrence :geek:

[thefastestz]

I know they say no welding required but when after a week the the longest pipe fell off.

I just went to a muffler shop and paid the $30 to get it welded on.

No problems after that

PS i also had added a 6-1 header.

[seerex]

I also have the 6 into 1 header, thinkng of getting it up there and tight then have someone touch it up a bit , not a muffler guy

[Smokey]

Get the header coated by Jet Hot, or at the very least wrap it in thermal wrap. Headers get very hot, which will affect the intake air temp. Lower temps=higher output.

[seerex]

who does the jet hot ? is it like the aluminized headers?

[Smokey]

Try this link . You can get the info you need here.

[dogma420]

Do the coating yourself and save $$$$$

http://www.jegs.com/cgi-bin/ncommerce3/ProductDisplay?prrfnbr=3895&prmenbr=361

Works well did this myself.

Question as well---

I use the 3 into 2 msa header....what does everyone think of this setup vs. equal length 6 into 1?