well im wondering

[Fun_in_my_z]

!m wondering for my 260 i have a 5 speed trans. Would i have to recut the floor to make it work.

[Bambikiller240]

You should not have to cut the floor. Straight forward bolt-in.

[Fun_in_my_z]

thanks for the input. ill go put it in right now i wish. its going to be awhile yet i was just wondering.

[Bambikiller240]

Originally posted by mperdue

I understand that when you put a ZX 5-speed into a 240Z, you have to cut the tunnel or switch to a 280Z stick. This isn't the case for the 260Z's? Does it matter if it's an early or late 260Z or did they all have the same chassis (just different bumpers).

michael

I'm not sure about the ZX trans. I was assuming a 280Z 5 speed.

[Victor Laury]

The problem with the question is, which 5 speed? The FS5C71B fitted to all the NA and the earliest turbosXZ's are a bolt-in. The T5 units from the turbos are a pain. Search "T5" for more details or a good T5 install FAQ here

[Fun_in_my_z]

the trans came out of a 73 datsun truck. i donno if thats how im going or not i might try it . ive got to 4 speeds and a automatic.

lots of choices.

i dont evan no if the 5 speed will fit i just got the car yesterday so im just comming up with ideas

[Smokey]

Hmm, not sure if that tranny will bolt up to the L series engine. More importantly, trucks are geared lower to tow and do manual labor. The gear ratios will prolly be wrong for your application. Just because you are gaining another gear ratio in the box you may still lose a lot of performance from the 4spd. Find a manual (or spec sheet) from the truck and check the ratios to be sure they will work for you.

[Fun_in_my_z]

i think ill just go with the 4 speed. the guy i got the truck from, his wife tried to kill her self and drove the thang off a bridge.so it has been full of water anyway.im not sure the 4 speed is in any better shap it came with the car. so i think ill take your advise.

[frank13]

"Don't take the car, you'll kill yourself!!!!!!!!!!!!! . :devious: