Body work Completed
By Mpower280z
- 847 views
- View Mpower280z's images
These shots are taken just after the car was painted. The car is a little dusty, but pictures till show how straight the body really is. The back of the car was made to pitch at the same angle as the front. The brakes and suspension have been plated and restored. The wheels are 16" Konig Troubles on a set of new Khumo's. Whats not pictured is the motor I just installed last night. Its a F54 block with an N42 head. That will soon change when I install the P90 head and turbine.
-
Gallery Statistics
-
Images39.6k
-
Comments14.4k
-
Albums643
-
-
-
Image Comments
-
I know a few people were following along on this- been a while since I last posted here- but finally all came together!
Mounted up and running strong! Still a few details to work out; but runs good, sounds good, feels good on the initial pulls. Super happy it worked out!
-
-
Well I decided to go for it -
Went with 42's and a TWM manifold. Still lots to sort out, but Ill start another thread on it somewhere and link it back here. Rought calculations hopefully put it in between an OER setup and a Mikuni PHH setup $wise.
-
By duffymahoney · Posted
I would probably do them in pairs, then each pair goes to a common shaft.
-
Part of running a single shared throttle shaft was for a super clean look- like how datsun_tokyo linked above has it.
I also still haven’t decided on the manifold- but was planning on the TWM one- seems to be the cleanest and allows me to run without all the linkages.
With that said I’m interested- I’ll shoot you PM.
-
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now