76 Z
By frankp
- 3,283 views
- View frankp's images
76Z,15x7 black mesh enkei's,215x60x15 dunlop D60-A2's, 2 1/4 exhaust,83ZXT-AFM,TWM throttle body,i made the aluminum fuel rail and strut brace,polished the cam cover & int.manifold,poly bushings,larger sway bar in front,CRANE CAMS PS20 coil,eliminated the ballast resister.also installed MSA air dam & early Z chrome bumpers,cut 2 coils off all the springs and installed KYB struts.
-
Gallery Statistics
-
-
Image Comments
-
I know a few people were following along on this- been a while since I last posted here- but finally all came together!
Mounted up and running strong! Still a few details to work out; but runs good, sounds good, feels good on the initial pulls. Super happy it worked out!
-
-
Well I decided to go for it -
Went with 42's and a TWM manifold. Still lots to sort out, but Ill start another thread on it somewhere and link it back here. Rought calculations hopefully put it in between an OER setup and a Mikuni PHH setup $wise.
-
By duffymahoney · Posted
I would probably do them in pairs, then each pair goes to a common shaft.
-
Part of running a single shared throttle shaft was for a super clean look- like how datsun_tokyo linked above has it.
I also still haven’t decided on the manifold- but was planning on the TWM one- seems to be the cleanest and allows me to run without all the linkages.
With that said I’m interested- I’ll shoot you PM.
-
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now