Jump to content

Classic Zcar Community

Classic Zcar Community

The Classic Zcar Community Pride Performance Preservation

- Forums
- Clubs
- Leaderboard
- Blogs
- Guidelines
- Gallery
- Downloads
- Subscriptions
- Donations

Existing user? Sign In
Sign In

Email Address

Password

Remember me
Not recommended on shared computers

Forgot your password?
Sign Up

Classic Zcar Community

Classic Zcar Community

The Classic Zcar Community Pride Performance Preservation

Welcome Guest! Please read more information about our club!

MSA Seat Belts - Z Retros w/Shoulder Harness & MSA Seat Covers

MSA Seat Belts - Z Retros w/Shoulder Harness & MSA Seat Covers

https://www.classiczcars.com/gallery/image/24589-msa-seat-belts-z-retros-wshoulder-harness-msa-seat-covers/

1973-240z.. This installation of the New MSA - 240z Retro seat belts with shoulder harness. This photo shows the installation of the Transmission Tunnel bracket and side belt to the existing hole. I used the L bracket to allow the side belt to feed nicely into the lap of the seat for improved wear and less stress on the belt.

From the category:

Interior

· 333 images

https://www.classiczcars.com/gallery/image/24589-msa-seat-belts-z-retros-wshoulder-harness-msa-seat-covers/

Create an account or sign in to comment

Register a new account

Sign In Now

Images 39.7k
Comments 14.4k
Albums 644

IMG_0101.jpeg

Nice toys!
I really like the color on your Z.

siteunseen

Thursday at 01:03 AM3 days
Mikuni HSR45 x 6 with ITG filters

I know a few people were following along on this- been a while since I last posted here- but finally all came together!
Mounted up and running strong! Still a few details to work out; but runs good, sounds good, feels good on the initial pulls. Super happy it worked out!

Demo243

May 16, 2024May 16
Mikuni HSR45 x 6 with ITG filters

Fun!

duffymahoney

December 17, 20231 yr
Mikuni HSR45 x 6 with ITG filters

Well I decided to go for it -

Went with 42's and a TWM manifold. Still lots to sort out, but Ill start another thread on it somewhere and link it back here. Rought calculations hopefully put it in between an OER setup and a Mikuni PHH setup $wise.

Demo243

December 16, 20231 yr
Mikuni HSR45 x 6 with ITG filters

I would probably do them in pairs, then each pair goes to a common shaft.

duffymahoney

December 7, 20231 yr

Important Information

By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.