.jpg.abbd1cd5c1998f6cb2a88ad8f2cde862.jpg)
.jpg.4c46f9ebb001ce11e333db904adf6a81.jpg)
Circa 1998
By Mike
- 2,353 views
- View Mike's images
Here's a good one. Two years after I created the Internet 240z Club. Which, eventually became the Classic Zcar Club you see now. Sitting in my 1971 240z after going through the entire frame with a cheap gravity fed sandblaster. Those were the days.
Photo Information
-
Gallery Statistics
-
-
Image Comments
-
I know a few people were following along on this- been a while since I last posted here- but finally all came together!
Mounted up and running strong! Still a few details to work out; but runs good, sounds good, feels good on the initial pulls. Super happy it worked out!
-
-
Well I decided to go for it -
Went with 42's and a TWM manifold. Still lots to sort out, but Ill start another thread on it somewhere and link it back here. Rought calculations hopefully put it in between an OER setup and a Mikuni PHH setup $wise.
-
By duffymahoney · Posted
I would probably do them in pairs, then each pair goes to a common shaft.
-
Part of running a single shared throttle shaft was for a super clean look- like how datsun_tokyo linked above has it.
I also still haven’t decided on the manifold- but was planning on the TWM one- seems to be the cleanest and allows me to run without all the linkages.
With that said I’m interested- I’ll shoot you PM.
-
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now