20170518_174444.jpg
By brent73z
- 443 views
- View brent73z's images
complete restored from off with every bolt replaced. Pics say it all. Some work done by Z Car garage. Post is also on craigslist SF/Bay area
Photo Information
- Taken with samsung SM-G930V
- Focal Length 4.2 mm
- Exposure Time 1/193
- f Aperture f/1.7
- ISO Speed 40
-
Gallery Statistics
-
-
Image Comments
-
I know a few people were following along on this- been a while since I last posted here- but finally all came together!
Mounted up and running strong! Still a few details to work out; but runs good, sounds good, feels good on the initial pulls. Super happy it worked out!
-
-
Well I decided to go for it -
Went with 42's and a TWM manifold. Still lots to sort out, but Ill start another thread on it somewhere and link it back here. Rought calculations hopefully put it in between an OER setup and a Mikuni PHH setup $wise.
-
By duffymahoney · Posted
I would probably do them in pairs, then each pair goes to a common shaft.
-
Part of running a single shared throttle shaft was for a super clean look- like how datsun_tokyo linked above has it.
I also still haven’t decided on the manifold- but was planning on the TWM one- seems to be the cleanest and allows me to run without all the linkages.
With that said I’m interested- I’ll shoot you PM.
-
