Well Cell installation

Ron,

Nice job! I was wondering, how is the well cell held to the car? Do you have to run straps over the top?

Are your vent and fuel lines running through bulkhead fittings thru the floor inside the "well", or thru the stand-up wall?

Thankyou for your complement, i have seen your photos of your fuel cell and they are quite impressive. Because I am building a replica of an early Z race car that had a well cell, I have decided to be accurate to the orginal car. We are in the process of fabricating the straps that will hold the cell in place and I will have additional photos in the near future to document this.

The vent line will run out the side of the bulkhead and out through the tail light panel, the fuel lines will run out of the rear of the cell through the wheel well section. You cant really see it in these photos but the cell has a flat section at the back that allows plenty of room to run lines through.