Spherical bearing C. arm

I think nr240 did the same on his car. Will this make for a harder ride? I think this would be good for my car.

Gav, I don't think that this mod will cause a harsher ride by itself. The springs/shocks/sway bar/tires have the most effect on ride.

Very nice. My front suspension is at DP Racing getting a simular modification...surprized that your looking to run this on the street!?

Ron, I'm a maniac. I ran race slicks on the street, now I'm going to drive it with street tires (guess I'm getting older).

maniac's unite or untie!! ....Nice setup. I used the factory bolt with stepped spacers that fit into the spherical bearings. My set up is tricky to install as it is a slight interference fit.

I had to put a short piece of 9/16" rod thru the spacers and bearing to keep them located while I got them into the cross member. I put the real bolt in from the backside and that pushed the temporary alignment pin neatly out the front. Otherwise you need four hands!