Leaderboard
-
conedodger
Free Member7Points11,316Posts -
Zpenman
Free Member4Points88Posts -
Yarb
Subscriber
3Points1,718Posts -
siteunseen
Free Member1Points14,903Posts
Popular Content
Showing content with the highest reputation on 01/10/2025 in all areas
-
3 pointsI took the forum's advice and tied a gym sock around the end of the master cylinder otherwise I would probably have a new implant!3 points
-
3 points
-
1 pointThe heating and oil didn't work, so I kludged a brass air fitting to the fwd reservoir with epoxy and clamped the other fluid outlets shut with C-clamps. Once the air pressure reached 80 PSI, the stuck valve popped out like a gopher!
1 point -
1 point1 point
1 pointAha!! Many hours later... Once properly shaped, the piece is perfect! But as-delivered the shape was quite a bit off. Perhaps it warped in the Colombian sun before shipment! "Patience, grasshopper"
1 point
Important Information
By using this site, you agree to our Privacy Policy and Guidelines. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.