Greg Galotta

It's a 1977 sorry

Door panel on , window can be either up or down, I have it down now.

I got in my car yesterday closed the the door, and now it won't open. Sealed tight, won't open from the inside or out. Doesn't seem like either handle is disconnected either. Anyone help me. I tried holding the handle and forcing it open with no luck. There hasn't been a problem with it sticking before. Any ideas for me?

The vac lines fell apart in my hands, needless to say that was the problem. I replaced them all and I now have heat. Thanks for all your help.

Found the problem, was real easy, once I thouched the vaccum lines, they fell apart in my hands. Changed them all, I have heat, thanks for your help.

Thanks for all your help, the car is in the body shop, so as soon as it gets out I will check all the vacuum lines. Snd I will post what the problem is.

My 1977 280Z Heater blows out cold air any suggestions?

I'm sure the pressure isn't right in just comes out like when you turn a faucet on low, pours out, instead of streaming out.

Yesterday I also ran air through the gas line, air pressure was fine coming out, so no clogs,also back through the tank from the gas line. This is driving me crazy. It just won't stay running unless I floor it.

1977 280z, yes fuel injection. I have replace the fuel pump, relay, and pressure regulator. I got it to start yesterday, but it won't stay running. I pull the fuel filter off and ran it directly into the engine. Gas coming out of the line is clean. But the pressure isn't very strong, just seems to pour out not forceful at all.

I put a new header on, then went to start the car and it wants to crank but won't. I disconnected the EGR. All the injectors are working. I spray starting fluid in and it's starts and dies. I pulled the plugs and it seems like it's getting too much gas, but then again if it was getting enough I'd image that it would run. Any suggestions?

This site is great, thanks to all that have helped in the past. My drivers side door won't open from the outside, but it will open from the inside, so hard to see in there, is there an easy way to solve this problem.

I played with it for an hour last night. Tried to pop the latch. I looked at another door same model and the piece that moves to open the latch moves but doesn't pop the latch. I am moving it down and it moves a bit, still won't release.

Having a problem with my driverside door, it won't open from the outside or inside. I have been trying to push the release and still can't get it to open and suggestions, climbing over from the passinger side is killing me.