datsunson

Replaced the alternator and voltage regulator and no charge light! Thank you! I was going to replace the belt as well but wasn't sure how to get the thing off. I looked in the service manual and is just said to replace it. No steps on removing. Do you have take off the fan shroud and fan?

I just spent $90 on a new battery, so that shouldn't be it. The wiring for the alternator was screwed up, so I'll take a look at that and get back. But to be sure, the charge light on the vlotmeter means that the battery is not being recharged by the alternator and will eventually die? Is that correct?

I have a 77 280z that has had electrical problems since I got the thing. I believe I've got pretty much everything figured out and I'm ready to start driving it. But I'm not sure about the volt meter. I've got 3 questions... 1) The volt meter reads 12v when the car is off and no lights on. Is this normal, or is something staying on and draining the battery? 2) When the car is running, I've got 12v, but the red charge light stays on. What should I be looking for? 3) And last, my tach jumps all over the place when accelerating or above 4k.

77 a/t 280z the tach is acting very strange. it will rise w/ engine revolutions, but will then stop at the highest rpm it was just revved to. it stays and won't go back down!? it can be revved higher, but it sticks at the higher rpm on the tach and so on until it hits the rev limiter. the needle will then go back down after the car is turned off and sits for awhile. is it time for a new tach?

thanks again. you wouldn't happen to know a place to get a thermotime switch for a decent price and does the engine rotate clockwise or counter-clockwise looking at the front of the car?

77 a/t 280z there are 3 sensors on the upper radiator neck. one has a male bullet connector and the other 2 have clips with 2 wires going in to each. what are each of these sensors for? particularly the one that needs a 25mm socket

i can't thank you enough sblake. your knowledge of s30's seem to be bottomless

thank you

another thing, when it's cranking, the tach gradually moves up and stays. does this mean anything?

i acquired this car after the p.o. gave up on a wiring migraine. (search in electrical to see the ridiculousness) the owner before him had it running but went to work one day and came out to be unable to start it. i have fixed the wiring and i am getting fuel and spark. i can smell the fuel and know the distributor is firing when attempting to start it. the only thing is that the car has been sitting for about a year. it had a little under a half tank of gas when it was parked. i just put 5 gallons of premium in it w/ some fuel injector cleaner. it turns over but just won't start after about 30 minutes of trying. i don't know what the problem could be. it is blowing 2 fuses, dome light and flasher. has it just sat for too long and being stubborn, or is there something else i should be looking at?

which ones do you connect together? i see 2 green wires w/ male barrel connectors and 2 white/black wires w/ female barrel connectors

if the inhibitor switch and/or downshift solenoid are not connected, will this prevent the car from firing?

what manual is this from?

ha, right. 77 280z

does anyone have it? just the ones that connect under the passenger footwell that run into the engine bay

thanks for all the good info!

i've got an AT 77 and the 4 speed is coming off a 78. is this everything i need for a direct bolt in? searched for an hour and couldn't find this exact swap flywheel/bolts clutch assembly spacer plate tranny trans shifter and knob driveshaft trans mount & bracket clutch/brake pedal assembly clutch master/slave cylinders and hardlines

and found some interesting stuff. just might have found the problem to what might have prompted the PO to straightwire the fuse. got another question on a connection too. lemme know if i'm making progress or if this is just something else that needs to be fixed as for tomohawk, please don't post if you're going to be a sarcastic jackass

what's the average price of this harness? i might just get another one instead of trying to repair this one

i've got 4 of them, one for each link w/ 50A and 80A fuses. the casing is metal w/ 8 gauage wire. still no?

i hate doing things for the first time, takes so long. i'm thinking about fixing the harness, solder and heatshrink all problems. what are the gold electric boxes above the fuse box in passenger footwell? got a few more questions on what some components are w/ pics

thank you! i'll mess with it tomm

what rating links are suppose to go in there and what runs through these? it's a 77 280z at

here's the link to my problem - http://www.classiczcars.com/forums/showthread.php?p=250696#post250696

just got this z and it doesn't run. the previous owner told me he drove to work one day, and we he went to leave, it wouldn't start. so i popped the hood and found this and shook my head in disgust. i think these are relays(question 1) guessing he was trying to bypass something for a temp fix? the one on the left looks a lil toasted next, there are some wires just dangling by the battery