timsz

How do you attach the chrome vent if you put the drain tubes on ? Adhesive ? Thanks

Does the tail light finisher go over or under the license plate lamp ? Thank you.

I have welting that is by itself ( no weatherstrip attached to it ) and Kia weatherstrip. I also have the Precision welting with weatherstrip attached. Which would you use ? The Precision seems to be soft. Here's a couple pics of the Precision. Thank you.

Thank you

Do the 2 bolt holes go towards the front of car or the 1 hole ? Thanks

I see how it goes now.

I want to get this weatherstrip done. On the upper outer rear hatch seal, does the lip face towards the inner hatch or does it face towards the front of the car and the right and left side of the body. My weatherstrip has a round circle and a lip. Can't take a pic. Thanks

I used a razor blade on a long handle to remove my paint. Many layers. Worked great.

Thanks. I'm getting the Kia weatherstripping. I think I understand now.

I don't understand how the door welting and weatherstrip attach. The position of them. The welting is squeezed on and the W/S is glued on, but how. Can't find anything to help me. Can someone take a pic or draw a pic of how they go. Thank you very much.

When painting my 71, I took a blunt object and pushed the weatherstrip back towards the interior of the car. It took a few tries but it stuck back. I put tape over it, which helped hold it back. It will give it a much nicer appearance. Only 2/3 or so would stay back. But it was no problem. Easier to sand and polish

thanks

I painted my garnisher (black). Should I put some clear coat over it.

Thanks

Anybody have any tie rod nuts. I can't find any. MSA has the right one I believe. Thank you

I was messing with my booster and master cylinder the other day. The white o-ring was laying under them. Did it come from inside the brake booster ? Thanks

I'll check. I can't do it for a week or two. Thanks

I can't get carbs to idle down. They either rev high or when they calm down, it stalls. Any help until I can look closer at them? Thank you.

Could someone tell me what these 2 black wires are for beside key? Thank you, Oh 71.

I have the MSA aluminum driveshaft. Where you adjust the rod, at bottom of pic, it hits on the drive shaft. I tried to bend it, but it --------------------------------------------------------------------------comes back to same place. Anybody else had this problem ? Not a lot of room to work either. Thank you

I have the 280ZX distributor swap with the E-12 80 module, into my 71. I have juice coming out of coil going to dizzy, but cannot get juice coming out of dizzy to the plugs. Is there a way to check the E-12 80. There is no reading on the module. Resistance, etc. I have a MSD. I tried the MSD test and it works. Any help ? Thank you very much.

Thanks

Is the angle of these calipers alright ? I see posts that the bleeders should point straight up. I can take them off to bleed them, so I can get trapped air out. Should they be pointing straight up just for bleeding purposes ? Thank you very much.

I have 1. PM me. Thanks, TimsZ

Would anyone have one of these for the passenger seat ? I need it pretty fast. Thank you very much.