timsz

It's not an automatic.

Thanks

These two wires are in the wire bundle that goes to fuse box area. The same bundle that has the big white wire with red stripe- as in pic. I don't see them in any wiring diagram. What could they be for? Thank you.

It's a 12/71. I can't tell on wiring diagram.

Would anyone happen to know the location these bulbs go on the speedo ? One bulb has a red with blue stripe wire and another bulb has a red with blue stripe wire. One bulb has two wires, one is red and the other is red with a white stripe. The other bulb also has two wires, one is yellow with green stripe and one is green with yellow stripe. Thank you.

I'm doing the voltmeter for ammeter swap. The 71 240Z has a yellow with red stripe and a yellow wire. I think they're yellow. May have been white at one time. May have yellowed over time. It also has a black wire. I already connected wires for the voltmeter (not in the pic). The wires in these two pics are for the fuel guage. In the other pic there are green, yellow and black wires. Does it matter how I connect the green and yellow wires to the 240Z wires? Green to yellow with red stripe or green to yellow? Any help? Thank you very much.

Thanks. I have the Painless like in the pic. It's not that painless for me though. I'm trying to make the engine bay look nice. I need hotshot for mice, also.

I'm putting in a Hot Shot Plus unit. It says to disconnect the starter activation wire (on the S terminal) from the starter solenoid. Then it says to crimp on a ring terminal to a purple wire coming from the hot shot unit. Connect that to the terminal I disconnected the starter activation wire from.

The check valve does have a bracket to hold it to the firewall doesn't it? I thought I had seen pics of both, with and without. Should it be held down firm? Can you leave the valve unattached? Would anyone have a bracket I could purchase? Thank you very much.

Which one of the terminals in the pic is the S terminal or starter activation switch? What are the other terminals also? Is the S terminal the one that is wired to the starter? Thank you.

That's where I put the harness. Now I know where the wires go. Those wires still come out of harness.

These wires are in the rear passenger side, beside (underneath) the fuel filler. They look like 2 black wires going to 1 female spade terminal. Are they ground wires? Any help? Thank you.

My car is not on the road yet.

I have 71Z with F54 block and triple Mikunis. I was thinking of putting a catch can on it. Any opinions? Thank you.

I would like to buy the L28E, if you have one. Thank you very much.

Anybody have an xtra one?

I see now, I'm missing the plate.

Here's the pics. Am I missing something. Thank you.

Thank you. I forgot about the brackets. They are painted and put in a safe place. I always forget about stuff I put in a safe place.

What's going on here? Should the outer long bolts be that long, like in pic? There's a few inches extra sticking down. Thank you very much.

I have a D6k8-02 distributor. The tangs with the threads don't line up. You can see in the pic the hole with the threads sticking out. They are supposed to be bolted together aren't they? The spacer's tang is at 9 o'clock when put in car. Should I have a different spacer? thank you very much.

I have a D6k8-02 distributor. The tangs with the threads don't line up. You can see in the pic the hole with the threads sticking out. They are supposed to be bolted together aren't they? The spacer's tang is at 9 o'clock when put in car. Should I have a different spacer? thank you very much.

Is this bolt a ground bolt? It's on the passenger side, top of firewall. Thank you

Thanks

What are these holes for on drivers side of console? Thank you