Everything posted by Ron Carter
-
Side impact bars
-
door bars- roll cage
-
passenger side floor
- fuel cell mounting
- fuel cell mount I
- dash install center
- dash install, drivers side
- dash front view II
-
Belrose @ Vara Route 66
-
Fiberglass dash install
Thanks Panchovisa, Yeah will have to add some protection too, thanks for the reminder, hate to loose my feet to a wayward flywheel. IF you could forward some photos of your floor pan I would apreciate it. BTW, I have enjoyed the racing photos of your car too. You have a real gem.
-
front, with dash installed
-
Fiberglass Dash (top)
-
fiberglass dash installation
-
Fiberglass dash install
-
fuel cell bulkhead finished II
-
fuel cell bulkhead finished
- side marker removed
- blocked of antenna opening
- fuel cell bulkhead III
-
hole in roof to finish weld on roll cage
-
Well Cell installation
Thankyou for your complement, i have seen your photos of your fuel cell and they are quite impressive. Because I am building a replica of an early Z race car that had a well cell, I have decided to be accurate to the orginal car. We are in the process of fabricating the straps that will hold the cell in place and I will have additional photos in the near future to document this. The vent line will run out the side of the bulkhead and out through the tail light panel, the fuel lines will run out of the rear of the cell through the wheel well section. You cant really see it in these photos but the cell has a flat section at the back that allows plenty of room to run lines through.
-
bare metal...
-
front, after media blasting
-
interior after media blasting
-
after my car was media blasted
this is one of several photos after my car came back from the media blaster. I am very pleased that there is very little rust and no bondo!!