CEgg11

I am not an expert, but I didn't know you could remove a sparkplug with a screwdriver. As for the plug, if you remember the #6 going in easy, then it isn't likely cross threaded. Good luck!

Hi all - I thought I posted this last week, but I'll try again. There is a lot of talk on the forums, and I've looked on other sites, but I can't find a definite answer. I have the 12SW calipers and the 300ZX vented rotors, and then got the spacers recommended. What length in studs do I need? Does anyone know a part number, or any info on where to order?

I have the two plugs.

I have the one on the right, but the hold down screw for the distributor doesn't line up with the mount. It is further "in" by about 1/4 inch. I can drill another hole, but if the correct one is out there, I'd like it.

So I got the part from Z Source, and it doesn't match the ZX distributor. Neither does the one that is on my block, and the two mounting blocks aren't alike to each other. Besides returning the block, is there a 3rd option I need to know about? The distributor is marked d6k81-01 and 22100p9100

I think so, in another box. I will take pics tomorrow and post.

will sell cheap, plus shipping.

Hi everyone I was doing some Christmas cleaning and found an E31 head with both intake and exhaust manifolds attached. I am attaching a pic. Is the 48 manifold better than the 88? Does anyone want the E31? Curtis

I looked at Speedhut today, and they do make dual gauges, but only 4". The Z needs 2 1/8 I think.

Aftermarket I think, although I don't know how to make up for the lack of dual purpose gauges. I haven't really done any research yet.

rcb, if we can figure out a way to keep shipping down, I can be your go-fer. I don't mind.

I have a strut/spindle if you need, will sell for less than 500.....

I am a part time advance auto guy, so I will check to see if I can get, maybe at a discount.

I will, but I am going to be a few weeks out, still have to order gauges

The wire that goes to the seat belt sensor runs under the seat, and can be disconnected there. That's what I do. It can be put back together if need be.

That'll do, dude! Thanks!

Hi all. I have my dash out doing repairs and decided to replace the incandescent bulbs with LED. I've done the swap, but want to test that they work. Does anyone know the power lead to the bulb lights?

I have pulled my dash to do crack repairs, and have decided to replace the incandescent bulbs with LED. I've already bought the LEDs have replaced the old 194's with them. My Q is, which is the wire that feeds power to these bulbs? I want to test them before I put them back into the dash. Thanks all! Curtis

Sent you an email, Chuck. Disregard the Q about where you live, since you have it on your profile. Gotta read, Curtis....

Looked on ebay. I don't trust "classics2customs" or whatever it was.

240. I should have said.

No, that wasn't it. Was Z Car Source, in AZ. My bad if I led astray.

Hi all - I've checked MSA and Zedd, and don't see an option to just get one side. I haven't called either place, but no option online. Does anyone have one they wouldn't mind selling (or even donating)? I am that close to being on the road with this thing....

The website sent me an email confirming the order, but didn't charge my card yet. They showed having one for the ZX and one for the Z, so I'll keep an eye out, and if it doesn't charge soon, I'll let you know. I live in Cumming, closer to Canton.

Too late, Metal. I ordered one from Arizona Z. If it is bad, or they end up not having, I'll send you a message. I am northwest of Atlanta, though.