Johnny wick

240z sign of my glove box came off should i use crazy glue or epoxy to paste it back?

I want power acceleration and good current whie at idle for 15 to mins traffic jams

Just received this brand resistor i bought from amazon but it measures 4.2 ohms instead of 3 ohms. I measured it with my fluke 117 digital multimeter. Its a pitty amazon advertise it as 3 ohms.

One thing is running the car at high other thing is sitting on traffic where the plugs get fouled at idle

Should i clean the 6 plugs again with the brass brush and carb cleaner? I also have a new set of bpr6es. The current ones are ngk BPR5es.

Ok but do you want me to adjust the floats in both carbs?

Timing set to 17btdc, front carb set to 3.75 and rear carb lowered to 3.4 turns clockwise. Raced car on the highway 110 mph, few stops and couple of traffic light no longer than 1 minute idling. Plugs 1, 2, 3,4 and 5

Its at 14 right now. Will i damage the engine increasing to 17 btdc?

Remember rear carb is at 3.5 turns clockwise and front at 3.75 turns clockwise looking from top of the engine. Do you want me to reduce the mixture on the rear carb?

Ok

I only replaced valve seals in 4th cylinder.

Next step??? Clean all plugs again or new set?

Plugs 4, 5 and 6 rear carb at 3.5 turns clockwise

All plugs cleaned. Took the car for a nice long spin, some time idling during parking waiting to pick up my roasted chicken lunch and then back home. Plugs 1, 2 and 3 results:

Well im ready to start. What first? Measure ohms from rotor cap terminal to plug? Then, clean 6 plugs with brass brush and take car for spin after adjusting front carb to 3.75 turns?

No. Need to find one at local store. You want me to measure the resistance point to point first and then give you the results in ohms?

Ok. What should we tackle first? Floats adjustment with float syncs, or swapping spark plug leads or spraying carb cleaner to determine fuel leaks? Too many directions. I can also clean the 6 plugs with a brass brush and enrichen the mixture from 3.5 to 3.75 at the front carb and sent you pics of the 6 plugs. Let me know the course of action.

Should i pull the float out and bend the tang more?

This was the last measurement in 2020 during pandemic. Front and rear carbs

Nothing. Its unplugged. What about trying to adjust the floats more using float sync i purchased in 2020?

Ok help me with this. We already solved the coil mistery now we need to get these floats adjusted to 2.5 turns each carb.

More info regarding both remanufactured carbs by ztherapy. Needles have not been touched after ztherapy's work.

Pics of needles and bridge first front carb and next rear carb. 3.5 turns clockwise. 41 to 42 mm from base each needle.

From the top! Looking from the top always.