-
New Antenna wont work
That is the one i got it cost me 65 dollars. Its not bad same size and design as the oem. Sent from my LG-H901 using Tapatalk
-
New Antenna wont work
Sent from my LG-H901 using Tapatalk
-
New Antenna wont work
I got the new one on ebay. I got it working but i ripped the chip out and wired it directly to the motor. Sent from my LG-H901 using Tapatalk
-
No brakes
It could have i did replace the booster Sent from my LG-H901 using Tapatalk
-
New Antenna wont work
How many amp's should the switch be? Sent from my LG-H901 using Tapatalk
-
Alan2fast started following Wheel and tire size recommendations , New Antenna wont work and No brakes
-
New Antenna wont work
Hey every one go my factory antenna did not have. Mast when i got the car so i bought a new groove shark antenna. Problem is that it wont work with the factory radio toggle switch. So i got another toggle switch and i just cant get it to work im not sure how to wire it to the new toggle switch. Sent from my LG-H901 using Tapatalk
-
No brakes
Ok got the brakes fixed adjusted the rear and rebleed them all good know thanks for ever ones input Sent from my LG-H901 using Tapatalk
-
No brakes
Im going to readjust the rear. And rebleed and hope for the best Sent from my LG-H901 using Tapatalk
-
No brakes
Calipers are on the right sides with the bleeders on top. Sent from my LG-H901 using Tapatalk
-
No brakes
The rear brums are all new as well. Brakes are are oem stock new replacements. As far as Pulling the e-brake it feel pretty good right as you start pulling and harder at 6 clicks could maybe use a little readjusting. Sent from my LG-H901 using Tapatalk
-
No brakes
Ill give that a shot here shortly. How do i know what are adjusted Right Sent from my LG-H901 using Tapatalk
-
No brakes
Hey every one. Ok my problem with the 240z is i cant get the brakes to work. When the car is off there is some pressure but still pushes down. When i turn the car on there is noting the pedal drops to the floor the only braking power i have when the car is on is if i pump the pedal new master cylinder. New booster new pads rotors. Some new brake lines. Bleed the master cylinder bleed the brakes still the same. Any ideas whats going on? Sent from my LG-H901 using Tapatalk
-
Wheel and tire size recommendations
-
Wheel and tire size recommendations
73 240z Im running xxr 538 16x8 with 205x55 and 1.25 drop also havent had any problems Sent from my SM-N900T using Tapatalk
-
73 240z gauges not working
Yea i haven't really looked to hard times been tight Sent from my SM-N900T using Tapatalk