Everything posted by sblake01
-
Help! Tail Lights Out! 1972 240z
I'm not sure which fuse box a 72 has, console mounted or side panel mounted, but in either case, carefully check the fuse marked 'DOME LAMP-LUZ-INSTRU'. Should be a 10A. Don't just probe it in the fuse box. Take it out and check it making sure that the end caps aren't loose. And make sure that the fuse holders for that fuse are free of corrosion, etc.
-
Losing it!!
What does the pressure do if you press the accelerator? Be careful with that fuel pump inlet screen as there are no new replacements available.
-
Losing it!!
It should pretty much remain constant as 36. Does it go continue to go down causing the car to stall? If that's the case it sounds to me like DZR's synopsis is accurate. My car sat for four years before I got it and exibited the same symptoms. Eventually replaced the tank and it's been running ever since, over 11 years now.
-
77 dizzy with E12-80 module
Here's a write up on using the GM HEI module with a Datsun distributor. It's for a 620 pickup but the installation should be the same for a 280Z distributor. http://www.japanesenostalgiccar.com/forum/viewtopic.php?t=184
-
Losing it!!
Check the fuel pressure when you start it and see if it remains constant or drops as the car throttles up and down.
-
Losing it!!
I don't suggest swapping ECU's just yet. People always seem to suggest that but in my years of dealing with these cars I only actually seen one of those go bad and it was caused by the car owners lack of wiring skills. What John is referring to as 'located by the wiper tank' are actually dropping resistors not relays but I wouldn't look at those yet either. The statement "I got the car after it sat in a garage for a few years" leads me to ask if you checked the fuel tank for blockage caused by sediment from the old fuel. Fairly common problem on these cars when they sit for long periods with old gas in the tank.
-
Hls000248?
The front windshield and cowl both appear to be missing in that first pic.
-
78 280z Rough Idle When Hot!
Have you checked the temperature sensor?
-
hazard switch,PLEASE HELP
Not sure if it's linked to the dimmer, I have to look that up, but it is linked to the turn signals. A bad flasher switch will cause your turn signals not to work.
-
New to the site, but not to z's.
Well, what's important is that she likes it. I'm not a fan of FWD, transverse engines, etc. The semi retro Suburban styling is interesting though. I've seen people do some wild custom things with them.
-
New to the site, but not to z's.
Don't know if I'd want to pile kids into it though...........that's what this if for:
-
i'd take a rusty Z over this any day LOL
I don't know about that....maybe she could draw them!
-
fuel pump options
In the long run, you'll be better off with a stock pump. New or rebuilt. That one that they sell at most of the chain auto parts stores is junk. Won't last a year. I've never put one in my car but I've done a few for other people (while protesting and warning the owner of emminent failure but it's their money!). I've replaced one stock pump among the two cars I own that have that type of pump in ten years! And that one works fine now and is my spare after I cleaned it out and replaced the check valve.
-
77 dizzy with E12-80 module
I'd imagine that you would connect the red and green wires from the 77 dist. to the terminals on the module in the same relation as the red and green wires were connected from the ZX dist. For the external 'c' and 'b' terminals on the E12-80 module you'd wire them the same way you'd wire an E12-80 dist. in a non E12-80 car. How would you mount the module? Does it actually work? Don't know, I've never seen it done. Might be easier to use the far more plentiful and much less expensive GM HEI module. I have seen that done.
-
'78 280z only starts with starter fluid
After you get it started, assuming that it runs properly at that point, and you get it up to operating temperature and turn it off, will it start again on it's own? If not you've got more issues than just a cold start valve. Like Jeff said, more info is needed.
-
Where does your Z sleep at night?
And it has company:
-
Is this price ok?
Wouldn't even consider it without seeing it.
-
Need help locating
Those will be tough to find. In Garagegoon's link, the door weatherstrip for a 80 coupe is listed as unavailable as well as the hatch seals except for the inner. You could also try here but they don't list door seals: http://www.blackdragonauto.com/ICATALOG/Z/t.aspx?Page=12
-
Valve cover differences
It's looks like another varation of the ones made by Kakimoto Racing mentioned earlier in this thread.
-
What Other Z/Datsun would/do you own and why?
I had one of those...well it was a NX1600. It was my DD for about three years. Great MPG and fun to drive. My wife drove a Senta at the time though not a SE-R. The SE-R you speak of would actually be a 3rd generation Sentra. There were no SE-R's in the first and second generation. The blue Celica in the background was mine also.
-
What did you find under your seat?
I didn't find anything under the seats in my 280Z. It was a one owner car and in the little time I spent around the previous owner that made sense to me. He was a very meticulous individual. His home was spotless, his garage looked like a car had never been in it, the Z had never been smoked in (I made up for that), and even though the car sat in the driveway for quite some time, he said he'd come out and wash it once a week. The only thing I found in it was a pouch in the glovebox that had the warranty booklet, the owner's manual, the guarantee card, and an old insurance card and the window sticker, though it was folded up and showed it's age. It even has the can of air for the collapsible spare, both of which had never been used, along with a sealed bag with 4 lug nuts for the steel wheel in the spare.
-
Strange problem with 5speed swap into a '73 240
Don if your car has the original differential it should be a 3.36 R180. The 81 ZX 5 speed differential should be a 3.90 R200. You'll actually get better mpg with the stock rear end though it won't pull as well off the line plus the ZX R200 swap requires some modification.
-
73 fuel sending unit leakage/removal/ gasket?
280Zs have voltmeters. I've not checked the resistance on the sending unit but this scan should help. It's from the 78 FSM but the setup is the same for all years of the 280Z: And for the o ring, the Nissan part number is 17342-18000. They cost less than $2 and they were still available about a year and a half ago when I bought one.
-
Need help with my 260 date of Manufacture!
According to the Nissan Fast program, the fuel tanks are different or at least have different part numbers. I can't really address whether or not the tank and suspension would work because I haven't dealt much with 260Zs. I would think that they would since it's the early model but for a definitave answer I would defer to someone who has actually worked on them.
-
Need help with my 260 date of Manufacture!
How did you end up with my signature in your post? EDIT: I get it. You quoted one of my old posts but didn't properly parse the quote.