Reaves76280z

Thanks. Makes sense. I will keep looking around.

I'm finishing up the wiring as I near the end of the restoration of my '76 280z. There is a single black wire with a spade connector on the ignition switch. Any help on where it connects? You guys have been a great resource so far! Thanks!

Since I have a couple of spare intakes to rob parts from, do you think the parts will interchange so I can switch them out?

I'm having a problem with the throttle return on my 1976 280z. I'm finishing reassembly after a complete restoration of the car and I've run into an issue with my throttle return. Most other Z cars I've seen have a large throttle return spring attached to the linkage on the throttle body and to a post bolted to a bottom screw attaching the throttle body to the intake. My linkage has no hole to attach the spring to and no post attached to the bottom of the throttle body for the spring? Am I missing something? The throttle does not return well at all.

Thank you so much! I've spent hours looking for something they connect too!

I am just about to complete the installation of my dash on my 1976 280z. I have almost all my wiring connections completed. There are two white wires located beside the ecu on the drivers side footwell that I can't figure out where they go. Can anyone give me any help? Thanks.