2Forty

Thanks, that's the ticket

Installing exhaust pipes on MSA3-2-1 header. Does the short straight pipe go on the collector first or the longer slightly bent bent pipe go on first?

Installing exhaust pipes on MSA3-2-1 header. Does the short straight pipe go on the collector first or the longer slightly bent bent pipe go on first?

One connection was only wrapped and it came loose. I solder all connections and am now good to go. Thanks.

Have test light. Note:car was an auto converted at sometime to 4 speed. I have fixed some hacked wiring. What am I testing? I guess I could have a bad connection.

I would suggest draining the fuel tank and replacing the fuel filter.

I drove my 73 from my old house to new house. Replaced points with Pertronix ignition and flamethrower coil. 3 wire tach wasn't working and replaced that as well. Car starts but dies when key is released to run position. All fuses are good. After said problem I replaced solid state voltage regulater with stock voltage regulator with same results. Any ideas?

Bought one! Thanks.

Putting my 73 back together and found mounting bosses for choke cable bracket broken off. Anyone encounter this and what was your repair. I'm thinking of epoxying two nuts to the back of the console.

Thanks, Blue. But I need the mounting point of the cable that runs around the right side of the blower motor.

I have the Haynes and also the FSM but neither is definitive in how the cable sheath is held in place. There are small clips that hold the sheaths for the other three cables but I can't figure out how the air/vent/heat cable is secured.

Can someone take a quick pic of the passenger side underdash area, right side of blower motor? I have an idea where the cable clamp goes but I'm not certain.

I replaced a non-operational C/D player in my 73 with an original AM/FM radio. I'm guessing the "installer" used self tapping screws to hold the escutcheon plate on but it looks to me like the screw holes are threaded. What size do I need?

got it figured out. Just need to find where heavy red wire out of heater harness connects to.

Part# 99990-01043