240260280z

If you are attending, please email me ( philip@atlanticz.ca) with your email, hotel and cell phone at the conference. I'll put together a list and distribute via email to improve confidentiality (compared to posting this stuff on the forum). Maybe we can also organize an informal coffee, lunch, supper, drinks at a multi-purpose room at the hotel etc. First annual CZCC event?

WOW that is great 6min into the 2nd video!!!!

Also consider lack of free play in the master brake cylinder or and incorrect master or a malfunction in the master where it does not recoil.

Please email me with your phone number at the conference and where you are staying. I'll distribute to all in the list at the start of the thread. My email is philip@atlanticz.ca

I could make one with a resistor matrix and op-amps used as a comparators along with free-running ramp generator to read each array. Digital is really just quantized analogUE. I see chokes, you see core.

Another cause that I have read about is collapsing rubber brake hoses that don't let the pressure bleed off. The other causes (as mentioned above) are: 1. corroded pistons that stick 2. corroded disks that stick to the pad 3. warped disks that bind

You could also have a look up table method that plots MAP against RPM and gives the injector pulse width at that point. There would be a stack of these tables that match the engine temperature. Tweaks could be added but it should get the system roughly in the correct working area . The coil would provide the input signal for rpm counting and triggering.

Thanks for posting the door panel work and tool.... you taught me something new!

For stock 240z Cam sprockets: 0° (position 1) Cam Advance 4° (position 2) 8° (position 3) 9° (position 1 + 1 chain link) 13° (position 2 + 1 chain link) 17° (position 3 + 1 chain link) 18° (position 1 + 2 chain links) 22° (position 2 + 2 chain links) 26° (position 3 + 2 chain links) 27° (position 1 + 3 chain links) Cam Retard -1° (position 3 - 1 chain link) -5° (position 2 - 1 chain link) -9° (- 1 chain link) Note: Crank Advance is Cam Advance/2

Congrats! Almost there.... we are all hoping for the best.

FYI: I have had bad luck with solder joints and cars. I made a copper sniffer tube for my O2 sensor that shoves in the tail pipe. The solder joints have let go many times. The combination of heat and vibrations cause the soldered joints to come apart. For your application inside the engine, I would recommend steel tube and tig welding it for peace of mind....and not pieces of engine (if the solder fails).

Have fun!

Nope.... it is Canada's "FOX Faux News"

http://news.nationalpost.com/news/canada/newfoundland-man-drives-18km-in-wrecked-car-cannot-remember-hitting-moose-hey-buddy-you-got-no-roof-on-your-car

I would optimize final placement with the new tires in place.

Honda Insight Update: It is actually fun going slow on 3 cylinders with 12 valves. Just did a valve lsh adjust and same work as in a Z Beautiful valve train in that thang: 4 valves per cylinder off 1 cam with rollers and one intake valve is hydraulicly controlled.

It looks great Tom! I sure want to see it!

You da man!

Janet & I will be there Monday ~ noon Will Mad Mike be there?

Join the Z club in Austin if you have not already. Great group! http://czot.org/

Looks great! Wish I was there. My trip got postponed so hopefully in sept I'll be out to turn wrenches... or just drive

How to switch on the ice cold air conditioning in Canada:

It's when your wife beats you up but you don't leave your house.