Kiwi ZX+Zed

keep the rods for your stroker build man,same as L24 rods....173mm IIRC?

coming up again in a few weeks I see.

i know very little of the S30 design history, and what country it was marketed at specifically,but i think the position of the handbrake gives alot away.Corresct me if im wrong?What side of the road do the Japanese drive on?Ive not been there so do not know.

any spark at plugs

efi relay is in the car,not under the bonnet? Bad fusables will corrode and give out,so replace them first then start looking if the problem comes back.

yep.I have a fairlady Z and put a 260z dash in it,theres a few things to do,swap the harness is about 5mins work.

Hi guys. I finished my rebuild on the car and put the l28e I had into it replacing the l20aE. The porblem im having is,it misses once to operating temp and wont pull past 4500rpm.When its cold,it doesnt miss at all,just when warm. Im thinking it could be the standard dizzy I had so swap over from the L20e,I also had to keep the ECU and AFM from the L20e unit. Im going to check the pressure reg and filter later today,and look at converting to the ZX dizzy I have (e12-90?). Do you guys have any idea what the problem could be? Anyways,heres a pic of her as it sits.

I have a GS31 2+2 for sale.As in my avatar,but just done a 4yr rebuild/rust removal and total bare steel repaint in the original white with a subtle pearl added

with 20yrs of crashwork behind me....wouldnt worry about that,its cosmetic at most.You can feel safe no integrity has been lost.

try adjusting the striker plate/catch around a little.Put a glob of grease on the door latch and gently clost till you feel the first point of contact between the catches,open and see where the grease is,this will tell you which way to move your plate and such.

after 20yrs in the paint biz,i agree with all of Z's comments. A good hint is to hold a sponge over your panel to keep the "Slops" off it,just keep rewetting the sponge in a large bucket of water....comes in handy when youre wet-rubbing at 7am when its close to 0deg C outside,boil the jug empty into your bucket and enjoy warm hands.

my 77 JDM doesnt have one either

oh well...never mind eh,

As above,im eyeing an auction and it finishes in 3hrs from now. Can anyone tell me if they fit.Also the front strut tops,will they help me lower the front a little?Are they the ones that are shorter than 260z,or is that the back. Thanks in advance!