Search the Community
Showing results for tags 'template'.
-
So I drew out some templates today for the cardboard pieces that go on the rear strut towers under the diamond pattern vinyl. I posted them in pdf and dwg. One of them is larger than 8 1/2 x 11 240z cardboard strut tower.dwg strut tower carboard1.pdf strut tower cardboard2.pdf
-
Whenever I do body work on a panel that has holes in it to accommodate the pins on the back of the emblems, I usually cover over then with body filler. Often times these holes are a starting point for rust. I usually cut the pins off the back of the badge and attach them to the body using 3M autobody trim tape. With the holes covered and the pins removed it's hard to determine the exact location of the badge. Attached is a template I made for proper location of the emblems on the rear hatch . You can print it off, cut it out, place it on the right rear corner of the hatch and mark the exact location of the badges. The dots on the template are the exact location of where the pins were on the badge. These were for the rear hatch on my 73 240Z, not sure if it's the same on other model years 240Z hatch badges.pdf
- 2 replies
-
- 3
-
- 73 hatch badges
- badges
-
(and 4 more)
Tagged with: