Search the Community
Showing results for tags 'wiper'.
Found 2 results
-
I've been working on getting the electrical side of my '78 280z back to working and have run into a few issues. First off, my low beams do not work and I have confirmed its a grounding issue somewhere between the headlight plug and the switch by grounding it manually which makes them work. This also makes the high and low beams run at the same time which is not good. Second, while I was installing an upgraded wiper motor to replace my broken original one I had the motor working for a few minutes before lengthening the wires for permanent install then it stopped working completely even rewired multiple times. Third, My Blinkers do not work because I don't get power to the turn signal stock. When in the middle position it has 12v but in the two turn positions it has 0v. I have taken apart, cleaned, and made sure my combo switch works so I don't believe that works. I have also looked at the FSM but I am not sure where to go from here.
-
So I've been working like a madman on my 240z and replaced the wiper motor AND linkage (which I thought was the issue). The thing is this: Before installation, the motor works great and I can even turn the linkages freely by hand without issue. Once installed, the wipers won't move. This isn't the standard "wet glass needed" situation either. Without wipers on, the pegs don't rotate. Figured I'd ask for some help. The connections are all good, wiring is solid and the battery is fully charged. Thanks for the help!! Chris
