blinker question

[cst0215]

hello to all:

I have been fighting the dreaded turn signal problem which has been discussed so much on this board. On my 240z all turn signals work except the right rear.

I have tried cleaning the switch, replaced the hazard switch, replaced both flasher relays, etc. but have had no success.

I decided to run a new wire from the turn signal switch (green wire/black stripe) back to the lamp. This fixed my turn signal but now when I step on the brakes, my right turn signal indicator on the dash lights!

I then decided to tap into the wire at the hazard switch (red wire/yellow stripe) and still get the same results.

I know how most of you feel about screwing with the factory wiring and all, but since I am not "hacking" into any wires and just using a splice block to cut a nick in the insulation to gain contact.

If anyone who is better at reading those darn wiring diagrams could help me out and possibly tell me the right wire to hook to it would be so appreciated.

thanks...

[gema]

Check the grounds in the taillight wiring harness. Mine was off and the lamp wouldn't illuminate...wiggled it a bit, and voila. Of course, that was problem 2 of 1123242323 electrical problems, but hey...headway is headway.